105F is about 40C. 40C is fine for PLA. If you do have heat issues, the first solution is to use ABS plastic as it can handle temps up to about 90C. and I hope your motor never gets that hot. They also make a glass-filled nylon that is even stronger when hot and very stiff and hard with the glass microfiber inside.
About printed gears, Make the center to center distance adjustable. I've got a couple module 2.0 spur gears here I printed and it does not seem to matter if there is a 0.5% size error. I just move the spacing by 0.5%. They seem to be tolerant of running with zero clearance too. This helps with backlash. On Mon, Jun 1, 2020 at 10:26 AM Gene Heskett <[email protected]> wrote: > On Monday 01 June 2020 01:02:01 Gene Heskett wrote: > > > > > Second, my testing for motor heating may not have been close enough to > > stopped as I was just turning the speed down to about a tick a second > > from the generator which may not have been long enough to cause a > > current turndown. So I'll plug it in w/o any drive for a hour > > tomorrow to see if it still gets that hot. Maybe watch it with a > > kill-a-watt? > > Its been plugged in now for about 1h:20m, and without moving it, the > motor is up to about 104F. I've no clue what the half power time > actually is but its obviously kicked in. I'll put the kill-a-watt in > circuit and see if I can detect the diff. when hooked to the function > generator. > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > If we desire respect for the law, we must first make the law respectable. > - Louis D. Brandeis > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Chris Albertson Redondo Beach, California _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
