Producing a path for wire edm is the same as producing a path for a mill. It will be difficult to find a cam system to produce the path to cut with the rod bending machine.
On Fri, Jun 5, 2020, 2:45 PM N <[email protected]> wrote: > > I think LinuxCNC would be able to easily drive the shown machine. I > believe > > it will be VERY difficult to find a CAM system capable of creating the > > gcode program to describe the path. > > Somethin able to produce a path for EDM wirecutting? > > > On Wed, Jun 3, 2020, 12:54 PM Leonardo Marsaglia <[email protected]> > > wrote: > > > > > > > > > > Have plenty of wood on other side of the wall in my workshop > intended for > > > > heating. > > > > > > > > > > Next time I'll take a look at your place then lol. :) > > Yes in northern Europe in something a little bit better than a simple > shed, roof is good and it's very cheap. > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
