I don't have "regular" tools for this. So I have to touch one edge. Note the table position on the DRO. Then touch the other side and note the position. Then finally move the table to the average of the two positions and hope the DRO slides are accurate enough. Do all the moves from the same direction. Then repeat the entire operation on the other axis. Then do it again.
Use the LinuxCNC on-screen DRO but I'd rather trust glass 5uM slides. On Wed, Jul 1, 2020 at 9:12 AM Gene Heskett <ghesk...@shentel.net> wrote: > Greetings all; > > How do you folks find a center when there is not room enough to use your > regular tools? > -- Chris Albertson Redondo Beach, California _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
