Excellent job Sam. One question to the list in general. How are you managing the atenuation and phase displacement you get when you increase spindle rpm using eoffsets? Other than increasing the speed and accel of the axis I mean.
I could cut cams with some success but I really can't follow the shape and the phase with the same success and that's why I'm building a live tooling jig to cut at really low spindle RPM to avoid this effect as much as possible. My particular problem is worse because all the machining of the cams has to be aligned with a keyway in the camshafts. El dom., 12 jul. 2020 a las 5:12, John Dammeyer (<[email protected]>) escribió: > So question. > 1. would you post the G-Code that made that? > 2. I take it virtually 0 backlash on the cross slide? > 3. I was also impressed with how well the parting off went. Mine tends to > dig in. > John > > > > -----Original Message----- > > From: Sam Sokolik [mailto:[email protected]] > > Sent: July-11-20 7:39 PM > > To: Enhanced Machine Controller (EMC) > > Subject: [Emc-users] Because the hardware store was 4 miles away... > > > > Right? Am I right? > > > > https://youtu.be/wv7mMS5xKks > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
