On 8/2/20 2:43 PM, Gene Heskett wrote:
> One the right in particular, there is no room for anything. About 1mm > clearance between the plate and the upright carrying the PSU too. It's usually possible to pinch the wire handle on a bulldog clip and lift the compressed handle out of the spring steel clip once it's installed for a minimal clearance clip, although the curved back on the spring steel will probably protrude more than 1mm. > But now its slightly > cloudy with dried white school glue & lots of water mixed, so we'll see > how the adhesion works. Based on my experience, the adhesion will be terrible. I tested white Elmer's Glue-All and white Elmer's washable school glue and both provided terrible ABS adhesion on glass. The only glue that's worked well for me is glue stick. As I've repeatedly mentioned in this ongoing 3D printing discussion, I use Elmer's X-Treme glue stick. The thinnest possible application directly to glass (applied with a pound or more of normal force to a cold glass plate, with a slow steady motion) works well, but even better is a small smudge of glue on the glass plate with a few grams of water, evenly distributed across the glass plate to form a nearly invisible glue film when dried. _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
