Hi Marius,
On 9/1/20 9:29 AM, Marius wrote:
Hi Todd
I just need to run a simuation to show some GUI's and fucntionality.
Thanks I will try VitrualBox.
My test with 2 different version of LinuxCNC in Virtualbox works fine.
They share space with other 16 VMs for different tests like ROS, Ubuntu
firewalls, kubernetes, BSD, CentOS, etc.
Virtualbox is inside my Kubuntu workstation. I say go for it.
It would be more impressive if you had a low cost industrial SBC with
functional LinuxCNC and use it for simple demo with LEDs, switches, and
a stepper motor or two.
On 2020/09/01 18:18, Todd Zuercher wrote:
I don't think it really matters much. Just remember that a VM is only
capable of running Linuxcnc in simulation mode, because VMs are
incapable of realtime.
I have only used Virtualbox myself and it works fine for simulations.
Todd Zuercher
P. Graham Dunn Inc.
630 Henry Street
Dalton, Ohio 44618
Phone: (330)828-2105ext. 2031
.....
--
Rafael Skodlar
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
