> > To me support is more important than price if there isn't a huge > difference. I plan on buying a few more. But unless I start putting some > sort of kit together for a lathe or mill I can't see buying large > quantities.
I agree on that. The problem is I need to purchase 5 sets for the router only. And the 2 sets for the lathe and may be 2 more for a grinder that comes after the lathe. Unfortunately Argentina is not going thru good financial times (like the last 80 years) but now there are some restrictions to international purchases so I have to stay as low as possible on the budget to avoid complications. Sometimes I think I was born in the wrong place :( El sáb., 12 sept. 2020 a las 2:57, John Dammeyer (<[email protected]>) escribió: > > > > From: Leonardo Marsaglia [mailto:[email protected]] > > > > > > I've been using these > > > http://en.bergerda.com/ > > > and the support has been really good. Replaced the 2HP single phase > motor > > > with a 1.8kW AC Servo good to 3000 RPM. I had to make new pulleys for > it > > > but LinuxCNC runs it nicely with the 0-10V far east module and Mesa > 7i92H > > > PWM. Had to adjust one parameter so it didn't scream when braking to a > > > stop from 3000RPM. > > > > > > Once I get the second BoB installed I'll switch over to step/dir. I > had > > > the small 400W running the X axis on the mill. > > > https://youtu.be/43liAVILgHY > > > > > > That's a pretty cool setup John. I've talking to Donald and their prices > > are really good. But I couldn't believe those Lichuan servo motors are > even > > better priced than Bergerda ones. That's why I'm considering mostly for > the > > router because I need to fit 5 servo motors to drive it (2 for the Y axis > > of the gantry, 1 for the X axis and at least 2 motors for the two > spindles > > I plan to install one for high speed milling and one for low speed > > drilling). > > > > To me support is more important than price if there isn't a huge > difference. I plan on buying a few more. But unless I start putting some > sort of kit together for a lathe or mill I can't see buying large > quantities. > > John > > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
