On 03/19/2021 05:21 PM, Alan Condit wrote:
I finally got my PCB mill all wired up and I started with the stepconf
configuration that works with my X2 mill.
Neither the X axis or the Z axis work. They just shudder. However, the Y axis
works fine it will do 180 ipm. So I took the stepper off of the X axis to see
if it would turn by itself and it would not. It just shuddered. So I took the
motor off the Y axis and put it on the X to see if it would work and no joy. It
just shuddered. So just to check things out I put the motor from the X axis on
the Y axis and guess what it worked fine.
Any suggestions in where to go from here?
First thing is to check your wiring. If you have a couple
wires crossed up between driver and motor, you would get
this kind of issue. Also, if there is a wire that is not
making connection at the driver, you could get the same result.
Jon
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
