Greetings to the 3d printer folks;

I have ordered, and rx'd after about 2 months, an exact replacement for 
the Robin controller in this BIG bed slinger printer, but in changing 
it, I found the replacement display cable was 1, defective by being 
pierced in shipment cutting at least 3 conductors, 2, not shielded like 
the OEM cable, and 3, the ribbon connector on the replacement board is 
not from the same vendor, so the connector on the OEM board doesn't open 
using the usual pry its cover towards the incoming cable at the ends 
technique.

The OEM board has a death grip on the cable, a 20 lb pull won't move it.

Does anyone know how to release this older connector?

Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>


_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to