Okay, I found the answer on the ubuntu forum: Go *to settings manager > session and startup > application autostart* and disable the screen locker
On Fri, Sep 17, 2021 at 1:50 PM Eric Keller <[email protected]> wrote: > I just downloaded linuxcnc-2.8.2-buster.iso from linuxcnc.org yesterday > and installed it. After a period of inactivity (other than the latency > test running) it goes to the lock screen. > > I can't figure out where to change that behavior. It seems to blow up the > latency by over a factor of 10. I would at least like to disable this > because it's not good for a machine controller. > > I swear there was a thread about this on the ml, but I can't find it, > sorry. > Eric Keller > Boalsburg, Pennsylvania > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
