Den 2021-10-27 kl. 18:01, skrev John Dammeyer:
From: andy pugh [mailto:[email protected]]
On Wed, 27 Oct 2021 at 08:36, John Dammeyer <[email protected]> wrote:
we don't actually see the calculated parameters from say the G53 lines nor
whether it fails and the M71 is run.
Have you tried adding debug lines ot the subroutine?
(DEBUG, G53 G0 Z #<_ini[AXIS_Z]MAX_LIMIT> +
#<_ini[PROBE_SCREEN]Z_SAFE_TRAVEL_OFFSET>)
I admit that I am not sure that this works in remaps....
Where would this debug information show up if it did work?
John
Small message in down right corner there errors use to show up you ever
had any.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
