Lol - yes.. Wondering the torque.. The only thing I found so far was around 20ft-lbs.. That would be more than enough - doing a 4:1 reduction would give us around 200ipm and over 10k pounds of push... give or take..
On Tue, Nov 9, 2021 at 9:32 PM Ed <[email protected]> wrote: > On 11/9/21 8:46 PM, Sam Sokolik wrote: > > Anyone have specs on this brushed servo from the 70's? > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > If I remember correctly the 2000 in the part number is the rated speed. > Spin the motor at 2K RPM and measure voltage output. PM motor I presume. > > > Is this for your "new" lathe? > > > Ed. > > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
