I built a few plasmas with EMC, the trajectory planner was a problem at the time with it not being able to smoothly keep going between IJ arcs. This can cause problems in thin sheet ... maybe it is better now.
I always had trouble keeping the HF from the arc start out of the electronics. On Sat, 8 Jan 2022 at 09:58, Rob C <rclandro...@gmail.com> wrote: > you could put sides on it that will catch any sparks, or an enclosure > around it, same as I have for a 3d printer so it has its own heated > environment. > > you could also add a water table that will catch all downward metal swarf. > > On Fri, 7 Jan 2022, 21:51 Thaddeus Waldner, <thadw...@gmail.com> wrote: > > > Use a submerged torch. This will also take care of the smoke. > > > > > > Thaddeus Waldner > > Newdale School > > Elkton, SD 57026 > > ________________________________ > > From: Nicklas SB Karlsson <n...@nksb.eu> > > Sent: Friday, January 7, 2022 3:13:17 PM > > To: emc-users@lists.sourceforge.net <emc-users@lists.sourceforge.net> > > Subject: [Emc-users] CNC controlled, plasma torch > > > > Anyone used Linuxcnc with plasma torch here. > > > > > > There is another major problem, one third of building is allocated for > > firewood storage. Need a good way to keep sparks away from it. > > > > > > Nicklas Karlsson > > > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
