On 6/24/22 20:25, andy pugh wrote:
On Fri, 24 Jun 2022 at 23:48, gene heskett <[email protected]> wrote:
I could re-home it in 1% of that time if there was a *-code to do
that from within a program.
G10?
Maybe G10 and a MOD on the current position.
That might do the job. Can it fix G53 too? Or do I care? IDK.
You can just say "A = 0" with a touch-off.
In this case its B, plus that is not programmable and you
have to stop the program and do it manually.
So why does your use-case make this a homing question?
I might be 500,000 or more degrees from 0.00 at the end of a
smoothing cut with a small tool. Right now I'm carving hard
maple. I increased the speed for rotary by 10x, but that to be
well utilized, needs a 200k rev spindle, and this one tops at 24k.
It does it, but that also warms up the motor, which has a 3d
printed in carbon fiber filled PETG, shaft adapter which should
be kept below 150C else it might soften.
Thanks Andy.
Cheers, Gene Heskett.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/>
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
