On 1/31/23 11:09, Alan Condit wrote:
I installed 2.9pre on two of my Raspberry Pi4s from debs that I had
compiled earlier. However, I can’t find my write up on how to cross-compile
LinuxCNC for the RPi4 on my X86-64. Also, I found that the compile on the
RaspberryPi4 with a 240gb SSD runs almost as fast, or maybe a little
faster, as on the Intel with a hard-drive.
The problem that I am currently having is that the installation of the
required packages reports a problem with locale setup. LC_CTYPE, LANG, etc.
Has anybody else seen this? Have a fix?
I have got a pretty good script(manual) for creating a new SSD for a RPi4.
It involves using a Debian install image (minimal) and installing the
packages that I need. Maybe I will post it on the forum.
Cool!
How does your setup compare to the images from
<https://raspi.debian.net>, built with the script at
<https://salsa.debian.org/raspi-team/image-specs>? I've been using
those to build and run LinuxCNC on my Raspberry Pi 4.
And yeah, because of how fast the RPi4 is, I just build everything
there, natively. I don't feel any urge to cross-compile.
--
Sebastian Kuzminsky
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
