Leon I use a cheap Chinese vfd costs about 190usd And buy a encoder for it. About 50usd and I'm controlling two fanuc spindle motors here fine.
They auto tuned the motor in about 4 secs and run awesome. I can get 150 percent torque at zero rpm. If I run a pid loop in linuxcnc almost a servo level control response Have a look at the video there are links on there. I made it a few months ago https://youtu.be/vARlybdtC6Q I'll message you in WhatsApp too. On Tue, 13 Jun 2023, 07:40 Leonardo Marsaglia, <ldmarsag...@gmail.com> wrote: > Forgot to attach a picture of the label on the spindle drive. Sorry. > > El lun, 12 jun 2023 a las 16:33, Leonardo Marsaglia (< > ldmarsag...@gmail.com>) > escribió: > > > Hi guys, I hope you're all doing well > > > > Sorry for the OT but we have a problem with a Daewoo lathe and as always > > this is the first place I think of. > > > > So, this morning the lathe started up as always, but when we selected the > > gear to validate the spindle movement the screen showed a 409 SERVO ALARM > > and the spindle drive on the back was showing alarm number 12. From what > I > > could find on several forums this is an overload alarm and in the worst > > case scenario the IGBT firing module or the IGBT module itself could be > > damaged. > > > > Is there any way to check this in an easy manner? > > > > Also, is it possible to adapt a normal VFD in case this is the problem? > > Because maybe there are some Fanuc Serial protocol to analog voltage > > converters (I'm just wishing such an adapter exists) that could be used. > > > > Thanks as always for your help! > > > > Leonardo > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
