Not to be hasty but you are bringing up a really good topic - adding a tool length probing routine is in my list. I got one of those nice probes from aliexpress last week, I will ask about this topic when I actually get there. But for now I would like to understand how to proceed with the error that G0/G1 command is not executed and it just waits for something. Axis does not freeze - I can pause or stop execution of code without issues, it is not lagging. It just does not make sense. And these files worked just fine in previous retrofit, so syntax etc should be good.
Viesturs trešd., 2024. g. 6. nov., plkst. 20:36 — lietotājs John Dammeyer (<jo...@autoartisans.com>) rakstīja: > > The problems you are having aren't quite the same but coincidentally I am > also having issues with the M6 remap and probing a tool with tool table zero > length (drill in chuck) compared to a measured tool (end mill or 3mm tap in > holder). > > One time it works. The next time the drill bit is too high for the zero > position. When it was only a tad off I didn't see the issue until the 3mm > tap bottomed in the previously drilled hole and snapped. > > Other times it's clearly way too far away for zero. > I think it has something to do with the G59.3 used in the m6remap.ngc when > probing a tool on the tool setter. > > More when I figure out what is wrong. > John > > > -----Original Message----- > > From: Viesturs Lacis [mailto:viesturs.la...@gmail.com] > > Sent: November 6, 2024 9:32 AM > > To: Enhanced Machine Controller (EMC) > > Subject: [Emc-users] M6 remap issues > > > > Hello! > > > > I am stuck with M6 remap in the final stage of the Biesse retrofit. > > I suspect that not all of the mailing list readers are following the > > forum and vice versa, so I will share a link to my post with more > > detailed description: > > https://www.forum.linuxcnc.org/10-advanced-configuration/54366-remap- > > of-m6-not-working-correctly > > > > Any comments are appreciated. > > > > Viesturs > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
