Thanks Peter, Next question is, where can I download it? :)
El mié, 26 feb 2025 a las 23:00, Peter Wallace (<p...@mesanet.com>) escribió: > On Wed, 26 Feb 2025, Leonardo Marsaglia wrote: > > > Date: Wed, 26 Feb 2025 22:34:33 -0300 > > From: Leonardo Marsaglia <ldmarsag...@gmail.com> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <emc-users@lists.sourceforge.net> > > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net > > > > Subject: [Emc-users] HOME_USE_INDEX with steppers on MESA 7i95 (Probably > for > > PCW) > > > > Hello all, > > > > I'm making an emergency retrofit on one of our lathes and I'm using a > 7i95 > > to drive the servo motors using in stepper mode. > > > > I plan to use HOME_USE_INDEX and it seems now it's supported for steppers > > also, but I think I need to upgrade the firmware on my 7i95 to > incorporate > > this function. Is that right? > > > > Thanks a lot! > > > Yes, you need 7i95sdid.bit firmware for a (plain) 7I95 > and 7i95t_sdid.bin firmware for a 7I95T > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > Peter Wallace > Mesa Electronics > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
