Hi, Actually I haven't any plans about moving this project to use meson and ninja build system. Maybe someone from E devs could help with thing that you are reported, because personally I didn't even try to setup meson build system. If there are exists any issues with current cmake realisation - you are welcome for a report this.
NikaWhite On Fri, 2017-12-22 at 14:42 -0500, William L. Thomson Jr. wrote: > Ran into a build issue, maybe ninja specific not sure. I switched all > E > cmake based ebuilds over to ninja generator from autotools. Cmake > supports both autotools/make and ninja. Thus far I have yet to see > any > build issues specific to ninja. Though I suspect this maybe one. > > ninja: error: > '/tmp/portage/dev-util/efl-profiler-viewer- > 1.1/work/v1.1/po/efl_profiler.pot', > needed by 'po/po', missing and no known rule to make it > > I know meson has means to generate an initial pot file but I do not > believe cmake has such feature. > http://mesonbuild.com/Localisation.html > > Aside from that one aspect I much prefer cmake to meson for po file > management. Though meson can update PO files it does not do that > during > every build you have to run a target for that, same with the main pot > file, pros and cons. > > ------------------------------------------------------------------- > ----------- > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > enlightenment-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/enlightenment-devel ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ enlightenment-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/enlightenment-devel
