Greetings,
I was wondering if there's a way to shutdown the backplane interfaces on
certain DFE modules within a chassis. It would be an interesting feature to be
able to break a chassis in half. For example, say you have modules in slots
one through four. You could shutdown the backplane interfaces between slot one
and slots three and four. Then do the same for the backplane interfaces on
slot two.
I believe the backplane is passive for the most part. You'd have to shutdown
the interfaces individually at the module level.
I've seen malfunctioning hardware isolate an N7 into two, distinct instances of
the EOS code. Why not enable the end user to isolate the switch on his own?
What do you guys think? I'd bet this is possible when you're logged in as the
super secret debug user.
Thanks,
Lou Goddard
------------------ CONFIDENTIALITY NOTICE ---------------
This message, including any attachments, is for the sole use of the
intended recipient(s) and may contain privileged confidential information
protected by law. Any unauthorized review, use, disclosure or distribution
of this message is prohibited. If you are not the intended recipient, please
contact the sender by reply e-mail and destroy all copies of this message.
------------------ CONFIDENTIALITY NOTICE ---------------
--------
This message has been scanned for viruses and dangerous content by
MailScanner, and is believed to be clean.
---
To unsubscribe from enterasys, send email to [email protected] with the body:
unsubscribe enterasys [email protected]
