Hey Guys, can´t find the value to increase the logon count for ssh and console port connection. The default is one connection for ssh or serial console.
regards Jens Podbiera ---------------------------------------------------------------------------- Pfennigparade - Das Rehabilitationszentrum in München SIGMETA Informationsverarbeitung und Technik GmbH Integrationsunternehmen für körperbehinderte Menschen Rechenzentrum Enterasys Certified Specialist - Switching NMS Enterasys Certified Specialist - Policy Geschäftsadresse: Schleißheimer Str. 282, 80809 München Besucheradresse: Klopstockstr. 4, 80804 München [email protected] www.sigmeta.de www.pfennigparade.de SIGMETA Informationsverarbeitung und Technik GmbH Geschäftsführung: Michael Lieb, Reinhard Männer Schleißheimer Str. 282, 80809 München Registergericht München HRB 123804 Sitz der Gesellschaft: München -----Ursprüngliche Nachricht----- Von: David J. Rodrigues [mailto:[email protected]] Gesendet: Montag, 8. Dezember 2014 16:03 An: Enterasys Customer Mailing List Betreff: RE: [enterasys] N7 TACACS Hello Erik, Thank you for your prompt reply. The management interface was not correctly defined! No issue anymore. Working perfectly. Thank you once again ... David Rodrigues -----Original Message----- From: Erik Auerswald [mailto:[email protected]] Sent: sexta-feira, 28 de Novembro de 2014 08:42 To: Enterasys Customer Mailing List Subject: Re: [enterasys] N7 TACACS Hello David, the configuration looks fine, but it is possible that the N7 uses a different IP address than you expect it to use. Did you configure a default management address (set ip interface), or is the N7 using the outgoing interface IP? Did you enter this IP address in the TACACS+ server? You write that you did not see any packets from the N7 at the TACACS+ server, did you filter on the IP address you wanted the N7 to use? If you ping the TACACS+ server from the N7, what IP address does the N7 use? Is it the same you entered in the TACACS+ server? HTH, Erik -- Dipl.-Inform. Erik Auerswald http://www.fg-networking.de/ [email protected] T:+49-631-4149988-0 M:+49-176-64228513 Gesellschaft für Fundamental Generic Networking mbH Geschäftsführung: Volker Bauer, Jörg Mayer Gerichtsstand: Amtsgericht Kaiserslautern - HRB: 3630 On Thu, Nov 27, 2014 at 09:38:15PM +0000, David J. Rodrigues wrote: > Hello all! > > I have the following TACACS configuration, but not working!! > I have similar configuration on B, C, G series and works fine. > I ran wireshark on TACACS server, but there's no packets from N7. I can ping > both sides. > > Appreciate your help. > > begin > ! > # ***** NON-DEFAULT CONFIGURATION ***** ! > ! > # Chassis Firmware Revision: 07.62.04.0002 ! > # tacacs > set tacacs enable > set tacacs session accounting enable > set tacacs command authorization enable set tacacs command accounting > enable set tacacs server 1 timeout 5 set tacacs server 1 > xxx.xxx.xxx.xxx 49 :xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx: > set tacacs server 2 timeout 5 > set tacacs server 2 xxx.xxx.xxx.xxx 49 > :xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx: > ! > end > > David Rodrigues > > --- > To unsubscribe from enterasys, send email to [email protected] with the > body: unsubscribe enterasys [email protected] --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected] --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected] --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected]
