Hi, We're running gentoo linux, and just built Equalizer v1.10. During the build, there was this error:
[ 89%] Creating eqPly kd-Tree for rockerArm.ply /bin/sh: line 1: 17713 Segmentation fault ../../bin/eqPlyConverter /touro/dev/equalizer/v1.10/examples/eqPly/rockerArm.ply examples/eqPly/CMakeFiles/rockerArm.ply.le64.bin.dir/build.make:58: recipe for target 'examples/eqPly/CMakeFiles/rockerArm.ply.le64.bin' failed make[2]: *** [examples/eqPly/CMakeFiles/rockerArm.ply.le64.bin] Error 139 CMakeFiles/Makefile2:17249: recipe for target 'examples/eqPly/CMakeFiles/rockerArm.ply.le64.bin.dir/all' failed make[1]: *** [examples/eqPly/CMakeFiles/rockerArm.ply.le64.bin.dir/all] Error 2 It turns out eqPlyConverter (which is run during the build) would Segv (see above). Darren Lee traced it and found eqPlyConverter linked with opencv. The current version of opencv (media-libs/opencv-2.4.9:0/2.4) builds with qt4 by default. To successfully compile, opencv can be emerged without qt4. Then Equalizer builds successfully. ie: if you're running gentoo linux, put this line in /etc/portage/package.use >=media-libs/opencv-2.4.9 -qt4 and then "emerge opencv" again (this will build opencv without qt4). Another alternative might be to build equalizer without opencv - but then there's no opencv.. (?) HTH, ben. -- View this message in context: http://software.1713.n2.nabble.com/Linux-v1-10-build-with-opencv-qt4-tp7587910.html Sent from the Equalizer - Parallel Rendering mailing list archive at Nabble.com. _______________________________________________ eq-dev mailing list [email protected] http://www.equalizergraphics.com/cgi-bin/mailman/listinfo/eq-dev http://www.equalizergraphics.com
