----[Please read http://ercoupers.com/disclaimer.htm before following any
advice in this forum.]----


First, the dip stick mystery.  

The tube the dip stick is in is generally below the level of the oil in
the 
tank.  The dip stick cap seals the top of the tube.  So, when you shut
down the 
engine, you have a sealed tube containing warm air in the top, the bottom
of 
which is submerged in oil.  As the trapped air cools it contracts (a lot
more 
than the hot oil would) and draws oil up into the tube.  When you open the
cap 
the oil drops back down into the tank, seaking its own level, but the
reading 
on the stick is artifically high.  The second reading is the correct one.

4-5 quarts is enough unless you experience engine cooling problems, which
you 
shouldn't.  The 6 qt requirement is arrived at by virtue of a
certification 
requirement:  The engine must be able to run without exceeding its maximum

allowed oil temperature with half of the specified oil level, thus 3
quarts is 
enough and 6 is what they mark the capacity at.  This is why there is a
slight 
difference between the C75, C85 and C90 oil "capacities".  Same tank, just

different markings.  

All C-series Continentals, including the O200 have a dry sump, so, 
theoretically, any oil level that is contained entirely within the tank
should be OK.  
Lycomings blow oil when the level is too high by virtue of the fact that
the 
crankshaft beats the oil around.   This should not happen on the C-series.

Regardless, there is anticdotal evidence that higher oil levels result in
more oil 
out the blowby tube. Go figure.

There are a number of oft overlooked causes for oil out the blowby tube.  
Here are some in no particular order:
- Leaking crankshaft seal allowing ram air to pressurize the crankcase.
- Excessive blowby pressurizing the crank case.
- Blowby tube incorrectly positioned, resulting in a low pressure in the
tube
- Missing extension on the crankcase vent elbow, especially on engines
with 
accessories on the nose (vacuum pump, fuel pump, injection pump). 

An oil separator should not be necessary, unless you're trying to keep a
show 
quality plane spotless.  If you've got excessive oil on the belly after a 
couple of hours, something is wrong.  Better to correct the problem than
put 
expensive lipstick on a bulldog.  And end up with bulldog teeth marks on
your butt 
later...

John
==========================================================================
====
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers/


<<attachment: winmail.dat>>

Reply via email to