----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
I've scanned a lot in but haven't run across anything referred to as Trim-o-Matic. I've spent much of the last week wreslting with a web server so you guys can see the drawings for yourselves. Give it another month and a half or so and I should have it all done. PS I haven't found anything about ski's either. Chris. On Mon, 17 Mar 2003 15:56:00 -0800 (PST), "Mitch Hines" wrote: ----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- Hello all, Don is looking information on the Trim-o-matic control kit that was once (and may still be) installed in his coupe. He is not yet on the list so I am forwarding this on his behalf. I believe that Chirs Trent has scanned a lot of the 'Coupe drawings from Bowling Green. How 'bout it, Chris? You have any drawings showing the Trim-o-matic? I'm sure Don would appriciate any information available. Regards, --mitch Mitch HinesAlon A-2 AircoupeN6369V Flight by machines heavier than air is unpracticaland insignificant, if not utterly impossible. - Simon Newcomb, 1902 ----- Original Message ----- From: Don Abbott To: [EMAIL PROTECTED] Sent: Sunday, March 16, 2003 5:14 PM Subject: Missing drawings Member 8024, Don Abbott N94411, Fort Myers, FL Hey Mitch! Thanks for the help in locating the source for repairing my fuel tanks. Unfortunately, my hard drive crashed and eliminated your reference to the Coupe lovers web site for help. I have a new one for you, and who ever else can help. In my airframe log #1 is an entry, when the plane was about 25 hours old, for the installation of a Trim-O-Matic kit SK-20. I looked between the seats, near the floor, and sure enough, the shaft for the Trim-O-Matic is there, but without an adjustment knob. I don't see any entries for removal of the kit, so I presume it still is installed and has been forgotten over the years. Since the plane flies left wing low, I hope I can lubricate the control, install a new knob and the Trim-O-Matic will once again be functional. I looked in the modification section of "A Touch Of Class" and found the Trim-O-Matic control kit was installed using Ercoupe service memo #54, and Erco drawing 415-52175, change A. Do you know where I could get my hands on these two documents? Maybe Bowling Green University? How about using the network for me? I would really appreciate whatever you can do. ========================================================================== ===To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/ ========================== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers/
<<attachment: winmail.dat>>
