----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Here's an esoteric
question someone out there may be able to answer.
I'm rebuilding my
seat frame! The frame is more rivets than sheet metal now and has
lost a bit of its structural integrity so I'm replacing it. A new
seat assy. is over $1300 via UNIVAIR. Rebuilding using new parts is far
cheaper. I don't even have to guess hard as to
where the big pieces go but some of the small gussets/brackets
have left me guessing . . . I'm using what was in my Coupe as a
"template" of sorts but it's been highly modified over the
years.
Are there any
close-up, multi-angle, engineering drawings of the seat that exists out
there? In fact, in general, the Service Manual and Parts
Manual leave a lot to be desired. Is there some
other pub/drawing set out there that I'm not aware of that gets down to the
details? If so, how do I get it?
Thanks,
Ross
N2704-H
Armada,
MI
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
