----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Hello Fellow Coupers,
I hope that this note finds you all well ![]()
.
May I ask you a Tech question, please?
I just received the MLG spacers to raise the tail from Skyport.
On their 337/instruction sheet it seems to indicate that you just jack up the gear leg, remove the piston and cylinder, separate it, slide the donut or washer assembly stack off and slide the spacer on. I have Belleville springs. I was under the impression that these springs have some kind of retainer clip that was difficult to remove and replace.
I want to replace the fluid (5606?) in there as well.
I haven't had a problem with overly hard MLG strut compression but would be happy to install the new wheel cylinder wiper cups in there now if it is just a good practice to do so.
Any advice is VERY much appreciated,
-Vince
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
