----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Hi Joe...
When I went to replace my column last year, I had a
difficult time trying to fit the bolts at the base of the column. The holes
would not line up well. I made a tool from a piece of wire close to the diameter
of the bolt, camfered one end and bent it 90 degrees to use as an alignment tool
for the bolts. Once allignment was close I slipped the bolt in. I also
premeasured and precut the cotter pins to fit before installing them. This
way I only had to bend over the tangs of the pin, since the area to work in is
very tight.
Removal of the header tank would help installation
and removal as well.
Cheers
Bettina & Bob
CF-LAV
415 C/D
S/N 719
CF-LAV
415 C/D
S/N 719
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
