----[Please read http://ercoupers.com/disclaimer.htm before following any
advice in this forum.]----
Larry
I had the same problem, at my last annual I cut a hole in the floorboard
right behind the control collum. Send me your e-mail and I'll send you a
pic. my e-mail is [EMAIL PROTECTED] Jim Phelps 2749H
----- Original Message -----
From: "Larry Snyder" <[EMAIL PROTECTED]>
To: "Ctech" <[email protected]>
Sent: Tuesday, November 22, 2005 7:37 PM
Subject: [COUPERS-TECH] Heat
----[Please read http://ercoupers.com/disclaimer.htm before following any
advice in this forum.]----
It's cooling off here in the Midwest, and I'm not getting very much if
any cabin heat in the old Ercoupe. Looking at the plumbing under the
cowl, it looks like a duct runs from the shroud around the left cylinders
to a valve that then goes into the cabin area, really low down, while the
fresh air duct goes higher in the cabin. I think I had read that the
cabin heat goes under the floor of the cockpit? If so, is there a way to
get some of that heat up from under the floor of the cockpit?
Thanks!
Larry
N99340
==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/
==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/
