----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Richard, I would take a look at the back of the mags to se if the P-lead(ground wire) is connected. About a month ago the same thing happened to me. I found that the crimped on ring that attaches the ground wire to the mag was old and brittle and it broke off. Installed a new one and problem fixed. Good luck. Dan N93805 -----Original Message----- From: Richard Wilkens [mailto:[EMAIL PROTECTED] Sent: Tuesday, February 21, 2006 7:46 PM To: [email protected] Subject: [COUPERS-TECH] Magneto Question ----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- Guys, A few weeks ago 904 developed a problem of not shutting off when the magneto switch was turned off. It only has the problem when the engine is hot. When it is cold the engine dies as soon as I turn it off, but if I fly it for an half hour I must turn the fuel off and wait for the carb to run out of fuel. I think this problem is only affecting one mag, but not sure which one. It still has its original magnetos. Any ideas? I have changed the switch. Richard N99904 ============================================================================ == To leave this forum go to: http://ercoupers.com/lists.htm ============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
