----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
I have seen "cam" engines
in the past. The eccentric is hard to manufacture on a mass basis; all one
does is pour molten metal in a mold for a crank shaft.
Percy in NM,
USA
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
Sent: Tuesday, May 09, 2006 8:18 AM
To: [email protected]
Subject: [COUPERS-TECH] Check out Reg/Regi Technologies Inc.
Sent: Tuesday, May 09, 2006 8:18 AM
To: [email protected]
Subject: [COUPERS-TECH] Check out Reg/Regi Technologies Inc.
Here is direct link to Rand CAm engines.
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
