----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
While rebuilding my engine, I have made a point of getting every single gasket that realgaskets makes for my C-75: oil filler cap, valve covers, pushrod housings, oil tank. Also I got the four pushrods converted to their spring loaded version. Eliacim N87071 > ----[Please read http://ercoupers.com/disclaimer.htm before following any > advice in this forum.]---- > > > All, > > I purchased a silicon gasket for my oil filler cap and installed it > on my 415C. It was actually a bit looser than the gaskets that were > one there, so I had little hope that it would fix anything. I went > flying for an hour and by golly, there is not a bit of oil on the > cowl. Looks like this did the trick! Not bad for $2.50! > > I took Andy Anderson's suggestion and got it from www.realgaskets.com. > > Larry > N99340 > ============================================================================== > To leave this forum go to: http://ercoupers.com/lists.htm > > > > ============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
