Wayne, I have seen that install, I would like to do it in mine, where can a get a copy? I think that I saw it once in the news letter long a go. Mark
--- In [email protected], [EMAIL PROTECTED] wrote: > > Al, > > I just dug out the receipt for my shoulder harnesses that I installed a while > back. I installed the harness system that David Smoler ( a former Alon > owner) developed for the Alon Aircoupes. This system has been installed in at > least one Mooney M-10, a few Alon's, and would probably work in an earlier model > (Ercoupe) as well. The AmSafe belts alone for this installation cost $547 for > the pair. That was the price after negotiating AmSafe's best price. List > price was much higher. These are TSO'd belts with the inertial reels attached. > I have been very happy with this installation. The inertial reels work > perfectly, allowing you to move around while not constantly pulling your shoulders > back like some inertial reels do. The rear attach points are as high as you > can get them and still have them centered correctly. This package was custom > designed by a DER, and David Smoler was selling the complete paperwork package > (about $25.00) with all of the stress analysis, a sample 337, parts list, etc, > attached. David did a great job putting this package together. I had no > problem at all getting it approved. This package was not STC'd at the time, and > was installed with a 337. I don't know if the STC'd package that you mentioned > is related to Smoler's design or not. I'm guessing not. > > Photos of installed harnesses attached. > > > Best Regards, > > Wayne DelRossi > Alon N5618F > Hours logged since restoration: 347.5 > > "Nobody has ever scientifically proven that life is supposed to be serious." > > > > > **************************************See AOL's top rated recipes > (http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004) >
