Hey Bill: You are probably way ahead of me and have already done this, but
just in case-- before you jack the airframe, remove the grease fitting and
make sure there is not any hardened grease in the fitting causing the
grease to not go in to the knee joint. If it is clear, then proceed with the
lifting etc.
Lynn Nelsen
In a message dated 3/17/2010 3:58:12 P.M. Eastern Daylight Time,
[email protected] writes:
One of my Knee Joint Pins on my Model G is not taking grease.
In order to service the bushing;
The manual suggests hoisting by the rear engine attach points with a heavy
pad at the rear of the tail cone. (not under the rear fairing}
Is there a better way to support the airplane while working on the Landing
Gear {Knee Joint}. I see no jack points or support points, other than
the Knee Joint I need to work on.
Thanks Bill
------------------------------------
Yahoo! Groups Links
