On Tue, 27 Aug 2002 [EMAIL PROTECTED] wrote:
> ...Do you know of any software that converts PS to DXF (or DWG)?
I think that would be difficult. PS is a pretty low-level representation,
aimed at putting ink on paper rather than representing higher-level ideas.
I don't know much about DXF, but I suspect the results of such a
conversion would be of limited use.
Henry Spencer
[EMAIL PROTECTED]
_______________________________________________
ERPS-list mailing list
[EMAIL PROTECTED]
http://lists.erps.org/mailman/listinfo/erps-list
