Hi Matt, the solution you found is the one I would have recommended. Just a comment:
On Wed, Jan 20, 2010 at 06:17:57PM -0800, Matt Jackson wrote: > The method I used to integrate the FB1111-0142 Piggy Back Controller is > as follows: > > (1) Pull configuration from slave at position 5 > 'ethercat xml -p 5 >> FB1111_EtherCATInfo.xml' > > (2) Use the generic slave block from the EtherLab Simulink Blockset > > (3) Convert the xml file to matlab object and save it to the workspace > >> FB1111_EtherCATInfo = EtherCATInfo(/some/path/FB1111_EtherCATInfo.xml); > >> save FB1111_EtherCATInfo Generally its enough to copy the XML file in the same directory as you model and just give the filename (in single quotes) to the generic slave block. > As a follow on, are there any known limitations to this technique? > Obviously you're at the mercy of the factory configuration. You can easily edit the created XML to add PDOs and PDO entries. Moreover you can use the SDO configuration field in the generic slave block's mask to add arbitrary SDO configurations, that are downloaded to the slave at configuration time. -- Best regards, Florian Pose http://etherlab.org _______________________________________________ etherlab-users mailing list etherlab-users@etherlab.org http://lists.etherlab.org/mailman/listinfo/etherlab-users
