The blank line is a mail/paste problem, there are not on the target. I have this output: ~ # ethercat slaves 0 0:0 PREOP + EK1100 EtherCAT-Koppler (2A E-Bus) 1 0:1 PREOP + EL2004 4Ch. Dig. Output 24V, 0.5A 2 0:2 PREOP + EL1034 4Ch. Dig. Input 24V, potential-free, 10µs 3 0:3 PREOP + EL1004 4Ch. Dig. Input 24V, 3ms 4 0:4 PREOP + EL2004 4K. Dig. Ausgang 24V, 0.5A 5 0:5 PREOP + EL2004 4K. Dig. Ausgang 24V, 0.5A ~ # ethercat config ~ #
I get the output a bow then running "ethercat slave" and "ethercat config" commands. "ethercat slaves" command seems OK, but "ethercat config" a bit disappointing. The master version is: IgH EtherCAT master devel 131f655c03d3+ Using generic device on a PowerPC. Do I have a master/commandlinetool problem? Best regards Kim Hedegaard Madsen -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Florian Pose Sent: 14. april 2010 15:08 To: [email protected] Subject: Re: [etherlab-users] ethercat config On Wed, Apr 14, 2010 at 12:44:53PM +0200, Kim H. Madsen wrote: > Shouldn't "ethercat config" always give an output with at least line per. > Slave? Yes. > I have this output: > > ~ # ethercat slaves > > 0 0:0 PREOP + EK1100 EtherCAT-Koppler (2A E-Bus) With the blank lines in between? Never seen this before. What revision are you using? BTW, this is 'ethercat slave' output. -- Best regards, Florian Pose http://etherlab.org _______________________________________________ etherlab-users mailing list [email protected] http://lists.etherlab.org/mailman/listinfo/etherlab-users _______________________________________________ etherlab-users mailing list [email protected] http://lists.etherlab.org/mailman/listinfo/etherlab-users
