Sorry. I asked for help too soon.
A few printk's later I found that I had a typo in the MAC address in
/etc/sysconfig/ethercat.
Working now.
Regards,
Wm
On 06/05/2012 03:52 PM, William Montgomery wrote:
I am using EtherCAT: Master driver 1.5.1 with Linux kernel 2.6.37.6.
I built with ./configure --enable-r8169 and all went well but when I
start the driver with:
"/etc/init.d/ethercat start" I see the following with dmesg:
EtherCAT: Master driver 1.5.1 0f7a243b03e4
EtherCAT: 1 master waiting for devices.
r8169 0000:03:0f.0: PCI INT A disabled
ec_r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
ec_r8169 0000:03:0f.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19
ec_r8169 0000:03:0f.0: (unregistered net_device): no PCI Express
capability
ec_r8169 0000:03:0f.0: eth2: RTL8110s at 0xf87e0000,
c4:3d:c7:80:4d:dd, XID 04000000 IRQ 19
The message "EtherCAT: Accepting device ..." never appears.
# ethercat master
shows:
Master0
Phase: Waiting for device...
Active: no
Slaves: 0
Ethernet devices:
Main: c4:3d:7c:80:4d:dd (waiting...)
Link: DOWN
Tx frames: 0
Rx frames: 0
Lost frames: 0
Tx bytes: 0
Tx errors: 0
Tx frame rate [1/s]: 0 0 0
Tx rate [KByte/s]: 0.0 0.0 0.0
Loss rate [1/s]: 0 0 0
Frame loss [%]: 0.0 0.0 0.0
Backup: None.
Distributed clocks:
Reference clock: None
Application time: 0
2000-01-01 00:00:00.000000000
Anyone know why the master doesn't accept the device?
Any suggestions for troubleshooting?
Regards,
Wm
_______________________________________________
etherlab-users mailing list
[email protected]
http://lists.etherlab.org/mailman/listinfo/etherlab-users
_______________________________________________
etherlab-users mailing list
[email protected]
http://lists.etherlab.org/mailman/listinfo/etherlab-users
