Hello,
I have the module EL7201 (servomotor terminal 50V DC, 4A) and a motor
(AM8131-0F20) connected to him, but I can not do
function properly.
I've configured with TwinCAT and I copy the configuration to my
application. I get read correctly the data from the
module (if I move the motor shaft I can see the position changing), but
I do not get running the motor.
According to the documentation for Beckhoff, to start the engine
without NC, I must follow a state machine through values
the control word, I send these values (I read them simultaneously
through SDOs) but the drive does not respond, the
value of the status word does not change and does not put the drive to
ready
Anyone have any idea what might be going on?
Thanks and regards
--
Carlos Jiménez
ENCOPIM S.L.
Ctra. de Ripollet a Santiga 104, P.I. Els Pinetons
E-08291 RIPOLLET (Barcelona)
Tel: (+34) 935 94 23 47
Fax: (+34) 935 94 64 15
==========================================================
La información contenida en la presente transmisión es confidencial y
su
uso únicamente está permitido a su(s) destinatario(s). Si Ud. no es la
persona destinataria de la presente transmisión, rogamos nos lo
comunique de manera inmediata por teléfono (+34 935 942 347) y destruya
cualquier copia de la misma (tanto digitales como en papel).
The information contained in this transmission is confidential and is
intended only for the use of the addressee(s). If you are not the
designated recipient of this transmission, please advise us immediately
by telephone (+34 935 942 347) and destroy any copies (digital and
paper).
==========================================================
_______________________________________________
etherlab-users mailing list
etherlab-users@etherlab.org
http://lists.etherlab.org/mailman/listinfo/etherlab-users
