Hello, We're using EtherLAB2, and Matlab R2014b. We have a problem that after compiling and running code, some signals are not available in TestManager. We have some outputs of calculation blocks (temperature, angle of encoder) that we're not using in our control loop, but would like to monitor in TestManager. Can you suggest what we could do to get these variables in TestManager? We do see some parameters / channels in TestManager, but it appears that some are optimized away. What we have tried sofar:
- Add test point / log data property on signal wire - Wire to "add" block -> this works temporarily because you can see the output of the "add" block, but it gets optimized away after a few compiles (or so it seems) - Make an atomic subblock and add something there. We'd like to have some way to 'scope' data that's calculated in our application. Do you have suggestions for settings in Simulink or Etherlab? With kind regards, Victor
_______________________________________________ etherlab-users mailing list [email protected] http://lists.etherlab.org/mailman/listinfo/etherlab-users
