Very good thanks. This will help a lot to keep the cost down. regards, ajith
______________________________________________________________________________________________ Ajith Boralugoda President CNC Lanka (PVT) Ltd 143/1 Meemanagoda Road Kalalgoda Pannipitiya Sri Lanka Tel/Fax : 0094112762624,009411493770 Hotline : 0094755002390 e-mail : [email protected] www.cnclanka.com CINCINNATI-SRILANKA (www.cincinnati-srilanka.com) Sole Agents for: MultiCam CNC Solutions from US ( www.multicam.com) AlphaCam (www.alphacam.com) and ArtCam (www.delcam.com) from UK. On Wed, Jan 10, 2018 at 11:37 AM, Mike O'Connor <[email protected]> wrote: > On 10/01/2018 3:50 PM, aj wrote: > > Hi! Mike, > > > > Please send me some details on the Leadshine. > > My intention was to get going a solid component set without much > > hassle.Later work on cutting cost by working on less expensive items > > Like you suggest. > > Please do share some details. > > It does not hurt to take a look at it. > > I suppose Getting LinuxCNC side working should not be a problem for me > > Ilike to keep it Open Source Controller as these days people talk > > about even promoting OpenSource > > CHIPs(https://slashdot.us15.list-manage.com/track/click?u= > aab6529d3675bd877963a652d&id=5148ab7ab9&e=b75feedc7f). > > I like it I am a fan of power to people!!! > > > > Thanks for sharing your thoughts. > > > > regards, > > ajith > The information is at https://goo.gl/zpygJS > > The documentation fully describes there Ethercat configuration and with > them having done the job correctly with no need for any external > software to configure the drive. Ethercat all the way. > > Note I've not used there drivers as get but I plan to test them soon. > (on the next few months) > > Cheers > Mike >
_______________________________________________ etherlab-users mailing list [email protected] http://lists.etherlab.org/mailman/listinfo/etherlab-users
