The Supercaps that you mentioned are present in every car with
electrically operated brakes. I know of the supercap bank in the trunk
of every Prius since pretty early on (I think the "Classic" 2001-2003
does not have it, but I am certain that since 2004 it is wht allows you
to apply brakes a few times when suddenly the aux battery goes out while
driving).
I checked the wiring diagram and indeed there is a "Brake Power Supply
Backup Unit (B15)" on the diagram. Typically those will *not* feed power
back to 12V aux battery, so this should not be the reason a car behaves
differently with a short or long disconnect of the aux battery.
What might be the case is a capacitor on the memory of a computer that
is designed to withstand a short disconnect, to allow you to change your
battery without losing all your settings.
Typically such a capacitor is not feeding back to the aux battery
either, so in any case clicking the loose battery wires together should
make very little difference in how long it takes for the car to behave
differently.

Also, the LBC validation happens without disconnecting the aux battery.
I know for sure as I never disconnect the 12V battery and when I swapped
my pack for a complete replacement pack from Washington State, the
yellow light on the dash came on and my Leaf was in Limp mode while I
only disconnected the (non-energized, due to the contactors in the pack)
HV lines and the control bus.
Just wheeling the original pack back under my Leaf and swapping the
connectors removed the Limp mode, so I know for a fact that the Leaf
validates the battery upon pressing the power button while the aux
battery is connected continuously, so it seems that you were looking at
the wrong thing.
Probably a trace of the EV bus as soon as the power button is depressed
(when a *lot* of communication is happening) will tell the story.
You may start the trace as soon as the brake is pressed.
Good luck!

Cor van de Water 
Chief Scientist 
Proxim Wireless 
  
office +1 408 383 7626                    Skype: cor_van_de_water 
XoIP   +31 87 784 1130                    private: cvandewater.info 

http://www.proxim.com

This email message (including any attachments) contains confidential and
proprietary information of Proxim Wireless Corporation.  If you received
this message in error, please delete it and notify the sender.  Any
unauthorized use, disclosure, distribution, or copying of any part of
this message is prohibited.


-----Original Message-----
From: EV [mailto:[email protected]] On Behalf Of Collin Kidder
via EV
Sent: Thursday, January 26, 2017 8:02 AM
To: Tom Parker; Electric Vehicle Discussion List
Subject: Re: [EVDL] Anyone interested in 2015 Leaf drivetrain or
interior/exterior/suspension parts?

10 minutes should have been enough. Chris suggested shorting the
positive and negative together to drain any capacitance and force the
ECUs to reset but I cannot imagine an ECU lasting 10 minutes on its
input capacitors. Though, I think that the leaf actually has a super
capacitor behind the rear seats so it might take a long time to drain
that off. It might be worth a try to make sure the 12v wiring is
really, truly drained. I did some work with adding a secondary battery
pack and initially made a number of bad mistakes that caused critical
ECU faults. Disconnecting the battery for a few minutes would not
allow me to clear the faults but disconnecting all day and trying it
again the next day would work. I think eventually someone suggested
shorting the battery terminals and doing that does allow for resets
more quickly. Though, if I'm right about the super cap being for the
12V power then you might want to discharge through a power resistor
and not just click the terminals together. It doesn't hurt to use a
resistor in either case. It's better for the car anyway.

Otherwise, it does appear we're looking at a message that is more
continuous. That doesn't mean that it necessarily happens quickly. On
the Tesla Model S there is a series of messages that transmit the VIN
number of the vehicle, presumably for authentication with various
components. These messages are only sent something like every 5
minutes. So, they'll show up as messages that aren't necessarily one
time and done but they've got a very long interval between
transmission. If you have the means to check transmission interval you
might try that. Actually, I have captures from various Leafs on the
powertrain bus and I do have the means to check the interval so I'll
check and see if I can find messages that maybe don't get transmitted
so often. A validation message might only be every second or couple of
seconds. There's no need to spam the bus with serial number validation
every 10ms. Really, I didn't think there was any need to do it more
than once but maybe it really does. This whole business of component
validation is just plain annoying. Are chop shops really that big of a
thing or are the automakers just that DIY hostile?

On Thu, Jan 26, 2017 at 4:33 AM, Tom Parker via EV <[email protected]>
wrote:
> On 24/01/17 23:25, Tom Parker via EV wrote:
>
>> On my car, there is only one frame that isn't repeated continuously
after
>> startup (0x603 is sent once, with a single byte payload which is 00
in my
>> captures).
>>
>> I'll try disconnecting the 12v battery tomorrow and see if anything
>> different happens at when it's connected, or during the first
startup.
>
>
> I removed the 12V battery and there was no activity on the EV CAN bus
when
> it was reconnected. There were also no new messages when I turned the
car
> on, and other than 0x603, they all streamed continuously. I waited
quite a
> long time (10 minutes maybe) before reconnecting the battery.
>
> I guess this means the BMS authentication is in the repeating
messages, or
> it is triggered by some other event than disconnecting the 12V
battery, or
> you can have the 12V battery disconnected for a very long time without
> breaking the BMS authentication.
>
> _______________________________________________
> UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
> http://lists.evdl.org/listinfo.cgi/ev-evdl.org
> Read EVAngel's EV News at http://evdl.org/evln/
> Please discuss EV drag racing at NEDRA
(http://groups.yahoo.com/group/NEDRA)
>
_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
Read EVAngel's EV News at http://evdl.org/evln/
Please discuss EV drag racing at NEDRA
(http://groups.yahoo.com/group/NEDRA)

_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
Read EVAngel's EV News at http://evdl.org/evln/
Please discuss EV drag racing at NEDRA (http://groups.yahoo.com/group/NEDRA)

Reply via email to