I am now seeing LED bulb failures. A total of 6 so far, and every one of them is not the LED's but the power circuit. I run them through a band saw to remove the "pingpong" plastic dome and remove two screws and the flat LED PCB Simply unplugs from pins on the power circuit.
The LEDs themselves are always good. I use the LED circuit board as-is in other lower voltage lighting projects. Bob -----Original Message----- From: EV <[email protected]> On Behalf Of ROBERT via EV Sent: Wednesday, July 25, 2018 6:56 PM To: Electric Vehicle Discussion List <[email protected]> Cc: ROBERT <[email protected]>; brucedp5 <[email protected]> Subject: Re: [EVDL] Reduce EV: Charging load on the grid ... The other advance that made LED lighting possible was low cost PWM LED drivers on a chip or with few components. Even today an LED cannot take a continuous high current. ________________________________ _______________________________________________ UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub http://lists.evdl.org/listinfo.cgi/ev-evdl.org Please discuss EV drag racing at NEDRA (http://groups.yahoo.com/group/NEDRA)
