On 20 Nov 2001 22:02:38 -0500 JP Rosevear <[EMAIL PROTECTED]> wrote:
> On Tue, 2001-11-20 at 20:36, Gerhard Schuck wrote: > > Hi, > > > > last Friday sync worked fine with the new RC2 release. Today it doesn't work at >all. My Palm says that it can't connect to the computer. What I found out: Even on >Friday (a far as I remember) sync worked only, if I choose "Syncronize" in the >Pilot-Link settings of the control center. It didn't work with "Use conduit >settings", which I find a little bit weird. Today, after sync had failed, I checked >Pilot-Link settings and found out that it had changed to "use conduit settings" >automatically. But even after changing back to "Syncronize" it didn't work. Somewhere >I read that one has to restart the daemon by right clicking on the Pilot-Link icon. >This doesn't work here. Right clicking shows no reaction. So I rebooted. Again the >settings had automatically changed from "Syncronize" to "Use conduit settings" and >sync didn't work. > > > > So what can I do? > > I'm unclear here, are you running the pilot-applet in the panel? > No, what I tried to explain was the configuration in "controll center/Advanced/Pilot Link". Also "controll center/Advanced/Pilot Coduits" is configured. What I actually do is just push the HotSync button while evolution is open. That' how it should work and it worked well yesterday. My point is, that it worked only with the Pilot Link settings configured as "Syncronize" (and not as "Use conduit settings"), and that this configuration now isn't saved. It always changes back to "Use conduit settings". Sorry if I'm unclear. My English is too bad and moreover I don't really understand what's going on between "gnome-pilot", "pilot-link", "conduits" and "evolution". By the way pilot-xfer on the command line works, for example for backup. Gerhard Schuck [EMAIL PROTECTED] _______________________________________________ evolution maillist - [EMAIL PROTECTED] http://lists.ximian.com/mailman/listinfo/evolution