On Wed, 2002-11-20 at 14:27, James Gallagher wrote: > On Wed, 2002-11-20 at 11:13, Mark Gordon wrote: > > On Wed, 2002-11-20 at 13:12, James Gallagher wrote: > > > Hi, > > > > > > I have a visor which was syncing nicely with 1.08. It won't sync with > > > 1.2. I've run gpilotd from the command line (in the past that helped me > > > get it set up properly) and here's what I see: > > > > > > [jimg@zanzibar jimg]$ gpilotd > > > gpilotd-Message: gnome-pilot 0.1.69 starting... > > > gpilotd-Message: compiled for pilot-link version 0.11.5 > > > gpilotd-Message: compiled with [VFS] [GOAD] [USB] [IrDA] > > > [Network] > > > gpilotd-Message: Activating CORBA server > > > gpilotd-Message: Watching Cradle (/dev/pilot) > > > gpilotd-Message: setting PILOTRATE=9600 > > > HOME environment variable not set? > > > > > > Gtk-WARNING **: cannot open display: > > > [jimg@zanzibar jimg]$ > > > > > > I have a stock Red Hat 7.3 system running on a Dell Inspiron 4100 laptop > > > (P III) with Ximian Gnome. > > > > > > Any help would be greatly appreciated! > > > > > > James > > > > > > PS. I read on the list that slowing things down to 9600 would fix this > > > but for me that produced no visible change. > > > > USB or serial? There was an earlier thread with a similar error using a > > USB connection, and the resolution was to configure gnome-pilot to use a > > "serial" connection. > > USB. You say 'serial' in quotes; is there a trick so that I can still > use the USB? Right now I have /dev/pilot linked to /dev/ttyUSB1. > > Again, thanks! > > James
As I understood it, you have to configure it in the capplet as "serial", even though it's USB attached to /dev/ttyUSB1. I haven't tried this myself, though. I think I'll go find a USB cradle for my Visor... -- Mark Gordon <[EMAIL PROTECTED]> _______________________________________________ evolution maillist - [EMAIL PROTECTED] http://lists.ximian.com/mailman/listinfo/evolution