Well, I'll answer it for you. If you're using the X.400 connector to connect sites, then complete the "Connected Sites" tab. Leave all the other X.400 settings alone. If you're using it to connect to a public X.400 service, then, yes, you have to fill in the myriad settings, and you must get them right and there's little room for error.
And here's a tip you didn't ask for. When specifying the other Exchange server to which you're connecting, use an IP address rather than hostname. Ed Crowley MCSE+Internet MVP kcCC+I Tech Consultant hp Services Protecting the world from PSTs and Bricked Backups! -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of tim Sent: Tuesday, August 27, 2002 6:45 PM To: Exchange Discussions Subject: Help I'm running exchange 5.5. I need to setup an X400 connector. I'm not sure all of all of the settings that need to be applied. Do I need to know the exact site that I'm connecting to????? Is there a wildcard character I can use???? Please advise _________________________________________________________________ List posting FAQ: http://www.swinc.com/resource/exch_faq.htm Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe: mailto:[EMAIL PROTECTED] Exchange List admin: [EMAIL PROTECTED] _________________________________________________________________ List posting FAQ: http://www.swinc.com/resource/exch_faq.htm Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe: mailto:[EMAIL PROTECTED] Exchange List admin: [EMAIL PROTECTED]
