am 2006-03-29 17:17 schrieb Jens Strohschnitter:
> okay. I have upgraded my 4.20 on a testmachine to 4.60. So nwildlsearch
> works. But a message via other users than the blocked ones that contained
> in my blacklist were also blocked. Any mail I sent to the host, from different
> users were blocked.
>
> My exim.conf-entry looks like:
> acl_smtp_data = acl_check_data
> .
> .
> .
> acl_check_data:
>
> deny message = $acl_m1 "${address:$h_From:}"
> set acl_m1 = ${lookup {${address:$h_From:}}
> nwildlsearch{/tmp/blacklist}}
> condition = ${if eq {$acl_m1} {} {no} {yes} }
>
>
> The log reports:
> 2006-03-29 17:21:37 1FOcUL-0000tn-KP H=XXXXX (XXXXXX) [1.1.1.1] F=<[EMAIL
> PROTECTED]> rejected after DATA
$h_From: contains the full header-line,
e.g.: "From: support blabla <[EMAIL PROTECTED]>"
${address:$h_From:} contains the extracted e-mail address
e.g.: "[EMAIL PROTECTED]"
if you want to filter out the word "support" from the variable $h_From:,
then you should not use the address extractor "${address:$h_From:}"
Write your config stanza as:
deny message = $acl_m1
set acl_m1 = ${lookup {$h_From:} nwildlsearch{/tmp/blacklist} }
condition = ${if eq {$acl_m1} {} {no} {yes} }
> The blacklist looks like:
> support : Blocked mails from support
this should be ok
Peter
--
## List details at http://www.exim.org/mailman/listinfo/exim-users
## Exim details at http://www.exim.org/
## Please use the Wiki with this list - http://www.exim.org/eximwiki/
