"make bzImage" resolved this for me.
Don
> -----Original Message-----
> From: Stefan Voelker [mailto:[EMAIL PROTECTED]]
> Sent: Wednesday, September 29, 1999 11:25 AM
> To: [EMAIL PROTECTED]
> Subject: [expert] weird lilo problem
>
>
> Hi all,
>
> I have a weird problem with lilo. I just recently installed
> Mandrake 6.1.
> The install went smooth. No problems. After finishing the
> installation,
> I decided to build a custom kernel, since the one that comes
> with Mandrake
> supports a lot of things I don't need and consequently is
> fairly big at
> 570kB. So I built custom kernel which is about 425kB. I modified
> /etc/lilo.conf copied the new kernel and System.map into /boot and ran
> lilo. Lilo failed. The error message said something to the
> extend that
> my custom kernel was too big. Lilo does not complain about
> the original
> Mandrake kernel being too big! Which makes???? Has anyone else
> encountered this problem? Any help would be greatly appreciated.
>
> Stefan
>
> P.S. The partition that holds the kernels is entirely within
> the first
> 1024 cylinders of my hard drive.
>
>
> -----
> Stefan Voelker My country is the world.
> Dept of Mech & Industr Engr My countrymen are
> all mankind.
> Univ of Illinois at Urbana-Champaign
> W.L. Garisson
>
>
