Hi,.. I need some advice in configuring my X windows setup for full performance as i dont think i am getting the best speed possible at this moment. I have a Matrox G400 with 32mb of memory, at the moment i run the svga server in 1600x1200x24, and when i try to play games or mesa/opengl demos they seem slower then i would expect. I am running the 2.2.17 kernel and have the mga / agpgart modules built in, i have also installed the mesa and mga / glx packages. I have configured my /etc/X11/glx.conf in what i think is reasonable (its all turned on),.. How do i get the x server to use the hardware acceleration of my card ?, and also how do i test that it is using it correctly. I dont seem to have an XF86_Accel x sever available and am a bit stuck. Also i thought the agpgart module would mean that my AGP card would be recognised as such, but the information under /proc indicates that my card is being used in pci mode. regards --- Matthew J Fletcher NPD Firmware --- ********************************************************************** Serck Controls Ltd, Rowley Drive, Coventry, CV3 4FH, UK Tel: 44 (0) 24 7630 5050 Fax: 44 (0) 24 7630 2437 Web: www.serck-controls.co.uk Admin: [EMAIL PROTECTED] ********************************************************************** This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email in error please notify the above. Any views or opinions presented are solely those of the author and do not necessarily represent those of Serck Controls Ltd. Please note that Serck Controls Ltd is able to, and reserves the right to, monitor e-mail communications passing through its network. This email has been checked for viruses. Serck Controls Ltd shall not be responsible for damage caused by any undetected virus. **********************************************************************
Keep in touch with http://mandrakeforum.com: Subscribe the "[EMAIL PROTECTED]" mailing list.
