[expert] auto-install failure with CS 1

[Christopher Kolar]

Hi all.  I have just done my first installations of CS 1 and am pleased with it (I normally use 7.x).  I am going to be setting up a couple of little network devices and want to replicate the installation exactly, so I made an auto-install disk.

Problem is that the install process dies when running auto install.  It runs a good long time, seems to put down all of the necessary RPM, and then gives me this:

rpmRunTransactions Finished  errors: 0

Entering Step "configure networking"

Entering Step "cryptographic"

error :(

Switched to console f2 for shell

Press ENTER to reboot

Note that at this time it also ejects the CD tray (I installed a couple of packages from the extras CD).  Even putting the CD in and closing the bay make no difference.  Rebooting restarts the auto install sequence over (and I tried rebooting with CD 2 in as well).  I  did install a couple of crypto packages on the original, but I am not sure why that would cause it to bomb.

I have given it two tries and am on the verge of giving up on the auto-install, any suggestions would be appreciated.  Thanks,

--chris

--
/////\\\\\/////\\\\\
 Christopher G. Kolar
   Director, Department of Instructional Technology
   Aurora University, Aurora, Illinois
 [EMAIL PROTECTED]  --  www.aurora.edu/~ckolar
        [PGP Public Key ID: 0xC6492C72]