Thanks to Bodo for the solution...
I added this to lilo, and it boots!!
append="hdd=none"
On Mon, May 07, 2001 at 01:15:31PM +0200, Bodo Huckestein wrote:
> Hi,
>
> I just saw your post on the mailing list archive. Did you solve your
> problem? Seems to be somewhat generic. I use 2.2.19 on 7.2 with an AMD
> Duron and VIA chipset. I have two HDs on ide0 and a CDROM and burner on
> ide1. Mine hangs a few lines further down after initializing the
> HDs. Doesn't happen with either hdc=none or hdd=none.
>
> ...Bodo
>On Tue, Apr 24, 2001 at 01:40:19PM -0700, Jason Shupe wrote:
>> speaking of 2.2.19 w/ mandrake 8.0
>>
>> I tried to use 2.2.19 with a k6-2 350 with VIA chipset and it stops
>> booting after probing the devices on the ide bus...
>>
>> ...
>>
>> Uniform Multi-Platform E-IDE driver Revision: 6.30
>> ide: Assuming 33Mhz system bus speed for PIO modes; override with idebus=xx
>> VP_IDE: IDE controller on PCI bus 00 dev 39
>> VP_IDE: chipset revision 6
>> VP_IDE: not 100% native mode: will probe irqs later
>> ide: Assuming 33Mhz system bus speed for PIO modes; override with idebus=xx
>> VP_IDE: VIA vt82c596a (rev 06) IDE UDMA33 controller on pci00:07.1
>> ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:DMA
>> ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:DMA, hdd:DMA
>> hda: Maxtor 91303D6, ATA DISK drive
>> hdc: ST39140A, ATA DISK drive
>> hdd: CRD-8322B, ATAPI CDROM drive
>>
>> then nothing more...
